Inspect
Board
Parts
Edit
Nothing on the board yet
Pick a part on the left and click the holes it sits in - U a chip, R a resistor, J a wire link, X a track cut.
Copying a layout you found somewhere? Open reference, load the picture, then behind board and trace it hole by hole.
Open a schematic, or a photo of somebody else’s layout, and it stays here
beside the board while you place parts.
It is a reference only. It never becomes part of the circuit, and it is not written into your exported .json.
It is a reference only. It never becomes part of the circuit, and it is not written into your exported .json.