« Back to Store

Second build · CD4046 VCO · PCB · One of a kind

Dragonfly

Synth Available · 1 of 1

POWER: 9V DC, center-negative, 2.1mm barrel (the standard guitar pedal supply). Power supply not included. Please check your supply before plugging in: a center-positive supply will not work.

The second Dragonfly, and the first one built on my own Dragonfly VCO PCB. A CD4046 phase-locked loop used as an oscillator, boxed upright in pink: pitch, range and volume across the middle, a mode toggle and a power toggle at the bottom, and an input jack between them that the loop can chase.

  • TypeCD4046 phase-locked-loop VCO, on a printed circuit board
  • ControlsThree knobs: pitch, range, volume. Two toggles: mode and power. A purple power LED
  • CircuitMy Dragonfly VCO, built on its own printed board, with an input jack on the face and the output on the end
  • Enclosure125B, stood upright, pink, the name in hot pink lettering across the top
  • Weight~8 oz
  • Power9V DC, center-negative barrel jack on the end
  • BuiltNovember 2026
  • StatusAvailable - one of a kind
$100 + $10 shipping Email to Buy

What it does

The CD4046 is a phase-locked loop chip, and one of the things inside it is a voltage-controlled oscillator that the rest of the chip is supposed to steer. This build uses that oscillator as the voice, and the mode toggle lets the rest of the loop back in, so the pitch follows whatever you feed the input. The board is my Dragonfly VCO PCB, and the build guide is free on this site.

Demo

Filmed by Onion Madder: this Dragonfly on the right, patched with the Cicada in the middle and a Spider on the left.

Controls

Pitch, range, volume
The three pink knobs, left to right. Range sets how far the pitch knob can reach.
Mode
The toggle at the bottom left. It changes what the chip does with its own loop: with it on, the oscillator chases whatever comes in on the input jack.
Power
The toggle at the bottom right, marked OFF. The purple LED in the middle is the power light.
The jacks
The input is the small jack on the face between the two toggles. The output is the small jack on the end, beside the DC socket.

Circuit: my own Dragonfly VCO PCB, sold in the kits section. Built, painted, and finished by Onion Madder as an original one-off - not affiliated with, endorsed by, or a clone of any commercial brand.